Breadboard and Jumper Wire Kit

The kit comes with a collection of parts that are the building blocks of all electronics, including op-amps, an instrumentation amplifier, a comparator, voltage regulators, switching regulators, digital logic gates, timers, temperature sensors, data converters, transistors, resistors, capacitors, LEDs, switches, a wiring kit and more.

The NI myDAQ student data acquisition device is designed to give students the ability to work on various electronic engineering course work and experiment hands-on with their projects anywhere, anytime. The NI myDAQ is a high-quality electronic lab instrumentation device that gives students the power to prototype electronic systems designs, control systems designs and electronic test circuits outside of the classroom and improve their comprehension with continuous reinforcement. Note: This version of the myDAQ is only for sale to students in the USA.

The Digilent myProto accessory board for the NI my-DAQ and NI my-RIO brings all your my-DAQ/my-RIO's signals to breadboard connections where they can be easily accessed using simple jumper wires, and even adds several useful I/O devices.

This kit is a must for the beginner. After practicing your soldering techniques on the special area of the board; you will be ready to assemble this European siren with flashing LED's. This kit also includes a soldering iron and wire cutters. This kit requires soldering.

NI Circuit Design Suite combines Multisim 14.3 and Ultiboard PCB Design Software, to offer students a complete set of tools for circuit design, simulation, validation, and PCB layout. The Circuit Design Suite software download helps you design electronic circuits to final printed circuit board protypes using intuitive and cost-effective tools.

Note: (Only for sale to Students and Faculty in the USA for lab preparation on personal computers, not for classroom or institutional use.)

The myDevBoard is an accessory board designed to connect directly to the NI myDAQ hardware. The Protoboard consists of a prototyping space as well as each I/O line from NI myDAQ broken out through quad contact blocks to make wiring easier.

Contains 140 lengths of pre-stripped; pre-formed #22 solid wire in various colors. Contains 14 different lengths of 10 pieces each. Storage case included.