PCNC1100 Power Drawbar

Eliminate the need to hand-tighten your drawbar and install this Power Draw Bar on your PCNC 1100 for lightning-fast tool changes with the push of a button.

The power drawbar is designed for use with the Tormach Tooling System (TTS), but easily pivots away to allow manual tightening of the drawbar if necessary for conventional R8 tooling.

• Requires 90 psi Air Supply (FRL unit recommended)
•Designed for use with Tormach Tooling System™ (TTS) toolholders
•Control Pendant (Standard) or Foot Pedal (Sold Separately) actuation
•Multi-stack air-over-air pneumatic cylinder ram actuation
•Does not load the Spindle Bearings
•Easily Pivots for Manual drawbar tightening for R8 tooling
•Integrates with Tormach ATC (sold separately)

The Power Drawbar kit includes pneumatic cylinder assembly stack, drawbar, electronic control circuitry, push-button pendant, and all necessary pneumatic tubing and electronic wiring.