Oops!! Our Bad!! That page was not found.

The Studica Robotics 1:1 motor kit can be used with the Studica Maverick or any FTC legal motor such as the Neverest Classic (6600 RPM) or the REV HD Hex motor (6000RPM). 

The Studica Robotics 1:1 motor kit can be used with the Studica Maverick or any FTC legal motor such as the Neverest Classic (6600 RPM) or the REV HD Hex motor (6000 RPM). The kit includes a faceplate which supports the Studica Robotics building platform. The shaft is press-fit onto the motor's shaft. It is recommended that the shaft be supported by a bearing (part # 76302 for the Studica building system).

NI myRIO Starter Accessory Kit Contents

• Barrel connector with leads
• Assorted capacitors
• Diodes
• 7-segment display
• Mechanical rotary encoder
• Photo interruptor (light sensor with LED) 
• Assorted op-amps
• Assorted LEDs 
• Small DC motor (1 VDC to 3 VDC, no load speed: 6600 rpm) 
• Microphone with audio jack
• MXP Breadboard Accessory
• Potentiometer (500 k?) 
• Relay
• Assorted resistors
• Piezoelectric sensor
• Photocell
• 2 Hall effect sensors (latch and switch) 
• Buzzer
• Assorted switches (DIP, slide, and rotary) 
• Thermistor (NTC: 10 k<U+2126>, 25 degrees) 
• Assorted transistors
• Force sensing resistor
• Wire kit