Stratom X-Hub Adapter for myRIO

The National Instruments myRIO-1900 is a portable reconfigurable I/O (RIO) device that students can use to design control, robotics, and mechatronics systems.
 

For motor control, use the MD2 Motor Driver

The NI myRIO Embedded Systems Accessory Kit contains common sensors, devices, and a display for your embedded systems projects as described in the NI myRIO Project Essentials Guide.

Required for APUS courses: ELEN430, ELEN435, ELEN436, ELEN440, ELEN498, ELEN499

(NI myRIO not included)

The NI myRIO Mechatronics Accessory Kit includes a variety of commonly used motors, sensors, and components.

NI myRIO Starter Accessory Kit Contents

• Barrel connector with leads
• Assorted capacitors
• Diodes
• 7-segment display
• Mechanical rotary encoder
• Photo interruptor (light sensor with LED) 
• Assorted op-amps
• Assorted LEDs 
• Small DC motor (1 VDC to 3 VDC, no load speed: 6600 rpm) 
• Microphone with audio jack
• MXP Breadboard Accessory
• Potentiometer (500 k?) 
• Relay
• Assorted resistors
• Piezoelectric sensor
• Photocell
• 2 Hall effect sensors (latch and switch) 
• Buzzer
• Assorted switches (DIP, slide, and rotary) 
• Thermistor (NTC: 10 k<U+2126>, 25 degrees) 
• Assorted transistors
• Force sensing resistor
• Wire kit

The MXP-MD2 is a next-generation high performance Motor Controller Driver and Sensor Adapter with many added features to make it ready to use in your robot project. The included VNH5019ATR-E Motor Controller ICs are very robust with high current output and several important protection features. Many other I/O options have been incorporated into this design to make it extremely easy to interface to several different sensors.