Close
Main Categories
    Filters
    Preferences
    Search

    Computer Engineering & Repair Tools

    View as Grid List
    Display per page

    20 Pin Screw Terminal Block Connector

    #70161
    $7.49
    (In stock)

    Used to replace or supplement connector on NI my-DAQ Kit.

    Basic Parts Kit

    #CK-1000
    $92.34
    ( 16 In stock)
    This Basic Parts Kit provides you with hundreds of parts to aid you in your prototype needs. Perform experiments first hand and develop a greater understanding of key concepts.

    Breadboard and Jumper Wire Kit

    #9880WK
    $10.95 $11.50
    ( 33 In stock)
    This NI Breadboard is a 830 tie point breadboard that comes with a 70 piece jumper wire set designed for use with National Instruments my-DAQ portable data acquisition device.

    myDAQ for Students - Hardware only

    #781325-01
    $254.95
    (In stock)

    The NI myDAQ student data acquisition device is designed to give students the ability to work on various electronic engineering course work and experiment hands-on with their projects anywhere, anytime. The NI myDAQ is a high-quality electronic lab instrumentation device that gives students the power to prototype electronic systems designs, control systems designs and electronic test circuits outside of the classroom and improve their comprehension with continuous reinforcement. Note: This version of the myDAQ is only for sale to students in the USA.

    Vernier Goniometer

    #GNM-BTA
    $188.98 $189.00
    ( 77 In stock)

    The Goniometer can be used to measure the dynamic motion of a limb during different types of physical activity.

    • A set of elastic straps are used to secure the sensor to the subject.
    • The lightweight and flexible joint arms allow the limb to move naturally.
    • Use it with an EKG Sensor to measure muscle activity during limb motion.
    • The sensor can also be detached from the base plate and flexible arms so it can be used in a variety of STEM and engineering activities.

    Vernier myDAQ Adapter

    #BT-MDAQ
    $69.00
    ( 16 In stock)

    The adapter includes two connectors for Vernier analog sensors and one connector for Vernier digital sensors. A screw terminal and header pins provide access to myDAQ lines not used by the connectors. This includes the two analog output lines, three digital lines (including the digital lines with the frequency and pulse width modulation outputs), and a +5 volt power terminal.