TinkerKit Tilt Sensor module can detect when it is at an angle. This module contains two contacts and a small metal ball. When the sensor is in its upright position, the ball bridges the two contacts, completing the circuit. When the board is tilted, the ball moves, and the circuit opens. When upright, the module outputs 5V and when it is tilted, it outputs 0V. When connected to an input on the Arduino using the TinkerKit Shield, you can expect to read a value of 1023 when in its upright position and 0 when it is titled.
This module is sensor. The connector is an output, which must be connected to one of the input connectors on the TinkerKit Shield.
The Titan Quad Motor Controller is a powerful, 4-channel CAN-based motor controller with a built-in fuse-box (for DC motors up to 20A).
Toolkit Wires [100 cm] module are 100 cm long wires designed for TinkerKit with a 3 pin jumper on both sides to easily connect your TinkerKit products.
PathPilot Controller for Tormach PCNC 1100 Mill, PCNC 770 Mill,PCNC 440 Mill and 15L Slant-PRO Lathe.
This kit includes the tools need to cut and join a urethane belt. Recommended for the 5mm Urethane Round Belt - part # 76400
The Goniometer can be used to measure the dynamic motion of a limb during different types of physical activity.
The Studica VMX is a powerful robotics controller with technology for enabling a rich development environment. The VMX is a Linux-based computing platform with software tools and features enabling access to cutting-edge sensors.
This kit may be used with older structure and most sensors. It includes everything required to connect to the collection and sensors. The only other electronic item required may be the SR-Pro Camera.