Used to replace or supplement connector on NI my-DAQ Kit.

Extend the reach of your MXP port by using this 8 inch cable to re-position you boards where you need them.  Compatible with MXP accessory boards like the protoboard, RIOduino and myRIO.

Features:

• Keyed male and female 34-pin connectors
• 28 AWG ribbon cable
• 34 conductor
• 8 inch length

Use it to power the Studica Smart Robot Servo Programmer or any other device requiring 6V output and a TJC8 connector. 

Specifications:

• 6V Output
• On/Off Power switch
• TJC8 connector
• Uses 4 x 1.5V AA Batteries (not included)

The Studica Robotics Cobra Line Follower Array provides 4 X QRE1113 IR reflectance sensor mounted on a 9mm pitch.  Each sensor is comprised of two parts - an IR emitting LED and an IR sensitive phototransistor. When you apply power to the VCC and GND pins the IR LED inside the sensor will illuminate.

Ideal for the myRIO.

• Inside Contact Diameter: 2.1mm
• Outside Contact Diameter: 5.5mm
• Termination Style: Solder Cup
• Voltage Rating: 12 V
• 6 Amp
• 1 meter cord length
• 18AWG or 20AWG wire guage
• DC connector type

The Dupont single pin, 4 wire, female to female, 22AWG cable (2 pack) is ideal for use with robotics design and competitions. 

The JST-GH to JST-GH Cable connects external sensors, breakout boards or other devices.

Detailed Specifications:

• Cable Length: 25 cm
• Connectors: 4-pin JST-GH (2)
• Wire Colors: Black, Red, Blue, Green

The Studica NiMH Battery Pack Charger, PP45, is used to recharge the 12V 3000 mAh NiMH Battery Pack - PP45.  

A 16A, 125VAC on/off panel mount snap-in power switch for use with Studica Robotics design builds.

The Studica Robotics Power Switch Plate is for use with the Power Switch (part# 70183).

The Powerpole Extension Cable is 50cm long and 14AWG wire gauge to handle heavier loads.

This set of 12 pieces includes,

• 2 x 20cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 2 x 40cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 2 x 60cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 6 x 3pin Dupont male to male connectors

Learn How to Control Motors, Sensors & Actuators with LabVIEW & NI myRIO.

The Robotics Sensor & Motor Training Kit from Studica Robotics is an affordable turnkey solution that allows you to teach your students how to control sensors and motors using LabVIEW and NI myRIO. It includes two project boards, one with different motors and the other board with most of the standard robotics sensors.

(NI myRIO, LabView and computer are not included).