iCrimp Ferrule Crimping Tool Kit, AWG 23-10 is a self-adjustable Ratchet Ferrule Crimper Plier with 770End Sleeve Ferrules Connector Terminals for Electricians, Contractors, Repair Support and Robotics designs.

A pack of 100 Studica Robotics M3 Kep Nuts for use with robotics design.

A pack of 100 Studica Robotics M3 Nyloc Nuts for robotics design.

The Studica Robotics M3 T-Slot Nut 100 pack, is a Hammer Head Series 20, used with any M3 screw and fits the Studica T-Slot Extrusion.

A zinc-plated, M3 x 10mm Button Head Cap Screw (pack of 50).

A zinc-plated, M3 x 10mm Socket Head Cap Screw (pack of 100).

A zinc-plated, M3 x 12mm Socket Head Cap Screw (pack of 100).

A zinc-plated, M3 x 30mm Socket Head Cap Screw (pack of 50).

A zinc-plated, M3 x 8mm Socket Head Cap Screw (pack of 100).

The Studica Robotics nylon Rubber Foot (4 pack) is used with our structure for robotics design builds.

The Studica Robotics Rubber Grommets (10 pack) are made for channels and plates and/or any structure with a 14mm hole. For use to protect wire or as a bumper. 

The Studica Robotics U-Channel Bumper (4 pack) is connected to the end of a 48mm U-Channel and helps to eliminate sharp corners that can cause damage when the robot is bumping into other objects. It also creates an aesthetically clean finish to your robot.

A cable lug crimping tool for use with your robotics builds and competitions.

The M3 x 10mm low profile screw with Kep Nut is a 304 Stainless Steel M3 Din 7991 countersunk hex socket flat head screw with a matching Kep Nut. This package is made for the Slide Rail, 288mm Length, 180mm Stroke and the Slide Rail, 384mm Length, 240mm Stroke

An insulated terminal ratchet wire crimping tool kit for use with your robotics design builds.

An iCrimp open barrel crimper for use with robotics design builds.