Makeblock 42BYG Through-type Lead Screw Stepper Motor

The Makeblock 42BYG Stepper Motor Bracket B has the same function as 42BYG Stepper Motor Bracket. It comes with a width of 40mm to adapt to your DIY project.

The Makeblock 57BYG Stepper Motor Bracket can be used as the structural support or connection point for Makeblock 57BYG Stepper Motor.

CNC Motor Bracket is specially designed for fixing 555 High-speed CNC Motor on your projects. With the 4mm through holes on this bracket, you are able to connect it to other Makeblock parts to create projects.

Gear 80T is designed for transmitting motion from a motor to a wheel or shaft. Usually it is used with shaft connector or flange bearing 4*8*3.

Makeblock plain ball bearing 8*16*5mm can be used with Makeblock 8mm bearing bracket A to support heavy mechanisms.

Makeblock 42BYG geared stepper motor is a simple, but very powerful stepper motor with high output torque and response speed but low noise and energy consumptionhas better performance.

It comes with higher torque than 42BYG stepper motor. It can be used as the power motor of some high-performance machine.

Specification:

• Step Angle (degrees) :1.8
• Phase Current: 2.8A
• Wire Number: 4
• Motor Length: 56mm
• Ratio: 5.18:1
• Output Shaft: D shaft 8mm

The Makeblock Plate 7×9 B-Blue is the same size as Plate 7×9, but it comes with some 8mm through holes.

Just like the other Makeblock mechanical parts, this little blue Stiffener is also made of anodized aluminum alloy. It will come in handy when you need to strengthen the joint of two parts, so that the whole structure will be more stable and maintain longer. Each side of the Stiffener has a M4 threaded hole, so it works great with most Makeblock mechanical parts, including metal beams, plates and brackets, etc., or other mechanical parts with M4 threaded holes.