Close
Main Categories
    Filters
    Preferences
    Search

    Makeblock Me 3-Axis Accelerometer and Gyro Sensor

    The Makeblock Me 3-Axis Accelerometer and Gyro Sensor is a motion processing module that can use to measure the angular rate and the acceleration information of your robot. The Me 3-Axis Accelerometer and Gyro Sensor is based on MPU-6050 that combines a 3-axis gyroscope, 3-axis accelerometer, and a Digital Motion Processor™ (DMP) capable of processing complex 9-axis Motion Fusion algorithms.

    MFR Part #: 11012
    $19.98
    Availability: 2 in stock

     

    Key Features:

    • Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
    • Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
    • Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronization and gesture detection
    • Embedded algorithms for run-time bias and compass calibration. No user intervention required
    • I2C Digital-output of 6 or 9-axis MotionFusion data in rotation matrix, quaternion, Euler Angle, or raw data format
    • 16mm interval M4 mounting holes, compatible with Makeblock beams
    • Easy wiring with 6 Pin RJ25 interface
       

    Specification:

    • Rated Voltage: 5V
    • Size: 24x48x 32mm (Length x Width x Height)
    Write your own review
    • Product can be reviewed only after purchasing it
    • Only registered users can write reviews
    • Bad
    • Excellent

     

    Key Features:

    • Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
    • Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
    • Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronization and gesture detection
    • Embedded algorithms for run-time bias and compass calibration. No user intervention required
    • I2C Digital-output of 6 or 9-axis MotionFusion data in rotation matrix, quaternion, Euler Angle, or raw data format
    • 16mm interval M4 mounting holes, compatible with Makeblock beams
    • Easy wiring with 6 Pin RJ25 interface
       

    Specification:

    • Rated Voltage: 5V
    • Size: 24x48x 32mm (Length x Width x Height)