Studica Blackhawk Expansion Board is a programmable expansion add on for your Mobile Robot.The board is used with the Studica MD2 driver board and the NI myRIO to control servo motors and to add additional sensor expansion and I/O including limit switches and relays.
Requires Studica MD2 Driver Board and NI myRIO with LabVIEW and the Studica Toolkit.
The Studica Robotic Expansion Board features:
The Studica Multi-Mode Smart Servo features all-steel gears and large amounts of torque. This angular programmable Servo can fill a variety of roles on your robot or project. In standard mode, it operates on a +/- 150-degree range. Using the Studica Smart Robot Servo Programmer (sold separately) the Multi-mode Smart Servo can be configured to run in continuous, standard, and custom angular mode. In continuous rotation mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.
Made of aluminum, the Studica Clamping Shaft Hub is used with flex and drive wheels
Specifcation:
Studica Robotics Light Weight Shaft Hubs are used with the 6mm D shafts. They have a 5mm set screw for tight clamping and seven M3 tapped mounting holes.
Used with Studica Omni and Mecanum wheels for a strong axel hold.
Specifications:
May be used with 6mm D-Shape Shaft to secure wheels in their position.
Step File
The 30 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
The 40 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
The 60 Tooth GT2-6mm Timing Belt Pulley can be used with any of the GT2 belts.
GT2-6mm Smooth Idler Pulley, H Type, w/3mm Inner Bore Bearing
GT2-6mm Timing Belt Clamp w/Set Screw
The Digilent myProto accessory board for the NI my-DAQ and NI my-RIO brings all your my-DAQ/my-RIO's signals to breadboard connections where they can be easily accessed using simple jumper wires, and even adds several useful I/O devices.
The NI myRIO Panel Mount Kit helps you quickly mount NI myRIO to a wall or integrate it in a project design. Created specifically for NI myRIO, the metal mounting panel allows NI myRIO to snap into place and be held securely.
The National Instruments myRIO-1900 is a portable reconfigurable I/O (RIO) device that students can use to design control, robotics, and mechatronics systems.
For motor control, use the MD2 Motor Driver
The NI myRIO Embedded Systems Accessory Kit contains common sensors, devices, and a display.
Required for APUS courses: ELEN430, ELEN435, ELEN436, ELEN440, ELEN498, ELEN499
(NI myRIO not included)
The NI myRIO Mechatronics Accessory Kit includes a variety of commonly used motors, sensors, and components.
NI myRIO Starter Accessory Kit Contents