Makeblock Me Gas Sensor Click on images to enlarge

Starting From: $9.53

Makeblock Me Gas Sensor

Me Gas Sensor is a MQ2 smoke sensor, which utilizes great reusability, long-term stability, short response time and durable performance. This kind of sensor is often used as a gas leak monitoring device. It is also suitable for detecting Liquefied Natural Gas (LNG), butane, propane, methane, alcohol, hydrogen, smoke, etc.

Features of Me Gas Sensor

  • The white area of this module is the reference area to contact metal beams
  • This sensor provides adjustable resistor to control sensitivity
  • Preheat for a while before use to keep it warm after preheating
  • Blue indicator will light on when a certain amount of flammable gas is accumulated and detected
  • Provides output port for digital and analog signal
  • Supports mBlock GUI programming and applicable to users of all ages
  • Adopt RJ25 port for easy connection
  • Includes pin-type of port to support most development boards including Arduino series

In Stock.

Part# 11028

$9.53

  • Operating voltage: 5.0V ± 0.1 V;
  • Heating voltage: 5.0V ± 0.1 V;
  • Heating resistor: 33Ω ± 5% (at room temperature);
  • Heating power: <800mw;
  • Warm up time: >24h;
  • Detection range: 100-10000 ppm;
  • Test temperature: 20 ± 2℃ (at standard condition);
  • Operating temperature: -20℃~50℃ / -4℉~122℉;
  • Relative humidity: < 95%RH;
  • Oxygen concentration: 21% (at standard condition)
  • Module dimension: 51 x 24 x 18mm (L x W x H)

Size Chart:
Height/Width/Length: 51 x 24 x 18mm (2 x 1 x 0.7inch)

Customer Reviews

No reviews found