Cables & Wiring
Cables & Wiring
Our cables and wires are used for power distribution, data communication, actuator control and sensor connectivity for your robot.
NavX2-Micro Adapter Cable
This cable is used and is included with each NavX2-Micro Robotics Navigation Sensor and is used for Control / Expansion Hub.
JST-GH to 4 Pin Dupont Cable (4 pack)
The JST-GH to 4 Pin Dupont Cable can be used for the VMX Controller.
Expansion Hub Encoder Cable
This cable is designed for the encoder that is pre-attached to the NeveRest Series of motors and gearmotors. It has a connector on the opposite end to directly interface with the REV Expansion Hub or the REV Control Hub.
Servo Power Block with XT30 Male to JST-VH Cable Bundle
The Studica Robotics Servo Power Block (75006) with the XT30 Male to JST-VH Cable (70180) Bundle is made for FIRST FTC Teams. The Servo Power Block is a 6V, 60W power injector that provides proper power for RC Servos. It does not interfere with the signal, it will only replace the power to the servo with 6V. The XT30 Male to JST-VH Cable allows you to plug directly into the REV Control Hub.
Note: This servo power block is legal for FIRST (FTC) competitions.
Maverick Encoder Cable for FTC
The Maverick Encoder Cable for FTC will connect the Maverick DC Gear Motor to the REV Control Hub.
XT30 Female to PP45 Cable
An XT30 Female to Anderson Powerpole 45 Cable for connecting a battery to a REV control hub.
PP45 to JST VH Cable
A PP45 to JST VH cable to connect motors to the REV expansion hub.
XT30 Extension Cable
The XT30 extension cable is a great solution to add distance to your wiring connections.