48mm U-Channel (Blue)

The Studica Robotics 6mm Hex-Shaft Hub (4 pack) is used to connect any Studica wheel and/or motor with a 6mm shaft.

The Studica Robotics 6mm Hex-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.

The Studica Robotics End Piece Plate (2 pack) is commonly fastened to the inside end of the U Channel. As with the other Studica Robotics building components, it has the common hole pattern which makes it easy to connect to other structure with very little or no additional machining required. 

A 128 tooth gear for robotics design, made from 6061-T6 aluminum, with a 6.35mm thickness and a 14mm hole diameter.

The Studica Robotics 30 Tooth Hex-Shaft Gear is ideal for use with robotics design builds.

A Studica Robotics 64-tooth gear (2 pack), for use with robotics design builds.

The Studica Robotics Small Thrust Ball Bearing is used for vertical and axial loads to withstand heavy loads. These ball bearings have track grooves on the upper and lower track boards to reduce friction. Use these with structure for any hole where an axial load will be applied.

A Studica Robotics 90 Tooth D-Shaft Gear for use with robotics design builds.