Made of aluminum, the Studica Robotics Clamping 6mm D-Shaft Hub is used with flex and drive wheels.

The Studica Robotics Light Weight 6mm D-Shaft Hub (2 pack) are used with 6mm D shafts. They have a 5mm set screw for tight clamping and seven M3 tapped mounting holes.

The Studica Robotics enhanced D-shaft wheel hub kit is ideal for use with the Omni and Mecanum wheels for a strong axle hold.

The Studica Robotics 20 Tooth GT2-6mm Timing Belt D-Shaft Pulley can be used with any of the GT2 belts. 

The Studica Robotics 30 Tooth GT2-6mm Timing Belt D-Shaft Pulley can be used with any of the GT2 belts in your robotics builds.

The Studica Robotics 60 Tooth GT2-6mm Timing Belt D-Shaft Pulley can be used with any of the GT2 belts in your robotics builds.

The Studica Robotics 80 Tooth GT2-6mm Timing Belt D-Shaft Pulley can be used with any of the GT2 belts in your robotics builds.

The Studica Robotics GT2-6mm Smooth Idler Pulley, H Type, w/3mm Inner Bore Bearing is ideal for your robotics design builds.

GT2-6mm Timing Belt Clamp w/Set Screw

This GT2 (also called 2GT) timing belt has a 2mm Pitch, 6mm width, and open 1000mm in length. Use any of the GT2 pulleys from Studica and the clamp kit.

Specifications:

• type: GT2 open-loop
• pitch: 2 mm
• width: 6 mm
• material: neoprene rubber, fiberglass reinforced
• belt shape: circular tooth profile

The Multi-Mode Smart Servo 200 rotates at 200RPM. This angular programmable Servo can fill a variety of roles on your robot or project. In standard mode, it operates on a +/- 150-degree range. Using the Studica Smart Robot Servo Programmer (sold separately) the Multi-mode Smart Servo can be configured to run in continuous, standard, and custom angular mode. In continuous rotation mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.  

The Studica Robotics Slide Rail is made of light weight aluminum, is 24mm wide, and is perfect for building a multi-stage slide system. Closed length is 288m, with a 180mm stroke, creating an extended length of 470mm. 

The Studica Robotics Slide Rail is made of light weight aluminum, is 24mm wide, and is perfect for building a multi-stage slide system. Closed length is 384mm, with a 240mm stroke, creating a 624mm extended length. 

The Studica Robotics Servo Arm can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.

The Studica Robotics Servo Hub Pro can be used with the Multi Mode Servo, Multi Mode Servo 200, and most servos with a 25 Tooth gear.

The Studica Robotics 30 Tooth D-Shaft Gear is ideal for use with robotics design builds.