The Studica Robotics 100mm Drive Wheel (4") with an axial width of 25mm, can be used as a simple wheel providing good traction on carpet and tile flooring. They can also be used for intake systems. Use with 1/2" Hex Shaft or 6mm Shaft Hub to use connect 6mm D-Shaft Axles.

The Studica Robotics 60 Tooth GT2-6mm Timing Belt D-Shaft Pulley can be used with any of the GT2 belts in your robotics builds.

The Studica Robotics 60 Tooth GT2-6mm Timing Belt Hex-Shaft Pulley can be used with any of the GT2 belts in your robotics builds.

This GT2 (also called 2GT) timing belt has a 2mm Pitch, 6mm width, and open 1000mm in length. Use any of the GT2 pulleys from Studica and the clamp kit.

Specifications:

• type: GT2 open-loop
• pitch: 2 mm
• width: 6 mm
• material: neoprene rubber, fiberglass reinforced
• belt shape: circular tooth profile

The Studica Robotics 30 Tooth D-Shaft Gear is ideal for use with robotics design builds.

The Studica Robotics 38mm Omni Wheel was designed as an odometry wheel that can fit inside most channel sizes. For ease of use, three cores were designed to fit the 6mm D-Shaft, 5mm Hex Shaft, and 7mm Hex Shaft. The wheel is open for easy use in any ecosystem with the provided different-sized cores.

The Studica Robotics 6mm D-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.

The Studica Robotics 24 Tooth 5mm Pitch GT2 D-Shaft Pulley is ideal for your robotics design builds.