The Studica Smart Robot Servo Programmer is used for programming the Studica Multi-Model Smart Servo Motor and for testing other standard Servos. Use it to program the Studica Servo motors to switch between continuous mode, standard mode, or any custom angular mode.  

Specifications:

• Requires 6 Volt battery pack with TJC8 connector or use the Studica 6V DC Battery Holder.
• Programming setting modes
  • Standard
  • Continuous
  • Angular

The Studica Robotics Titan Quad Motor Controller is a powerful, 4-channel CAN BUS -based motor controller with a built-in fuse-box (for DC motors up to 20A).

Has two compartments on the lid for tools and electronics.

• Material: PP
• Size: 59*36*32cm (23" x 14" x 12.6")
• Capacity: 55L

The Studica Robotics Linear Servo RC Actuator 50S-190N is a new linear servo motor which has a stroke of 50mm and a max force of 190N. 

Note: This actuator is legal for FIRST (FTC) competitions.

The Studica Robotics Linear Servo RC Actuator 140S-190N is a new linear servo motor which has a stroke of 140mm and a max force of 190N. 

Note: This actuator is legal for FIRST (FTC) competitions.

Made of aluminum, the Studica Robotics Clamping 6mm D-Shaft Hub is used with flex and drive wheels.

The Studica Robotics Light Weight 6mm D-Shaft Hub (2 pack) are used with 6mm D shafts. They have a 5mm set screw for tight clamping and seven M3 tapped mounting holes.

The Studica Robotics enhanced D-shaft wheel hub kit is ideal for use with the Omni and Mecanum wheels for a strong axle hold.