USB cable type A/B

Toolkit Wires [100 cm] module are 100 cm long wires designed for TinkerKit with a 3 pin jumper on both sides to easily connect your TinkerKit products.

Makeblock 42BYG geared stepper motor is a simple, but very powerful stepper motor with high output torque and response speed but low noise and energy consumptionhas better performance.

It comes with higher torque than 42BYG stepper motor. It can be used as the power motor of some high-performance machine.

Specification:

• Step Angle (degrees) :1.8
• Phase Current: 2.8A
• Wire Number: 4
• Motor Length: 56mm
• Ratio: 5.18:1
• Output Shaft: D shaft 8mm

The Makeblock Me Compass is a 3-axis digital compass. The main chip is Honeywell HMC5883L. On-board regulator provides stable power for HMC5883L.

Me Slide Potentiometer is one type of potentiometer that can be used to control volume, light intensity, motor speed, movement control, etc. in interactive projects.

Features

• Compatible with the Arduino sensor expansion board;

• Three 4mm mounting holes and one RJ25 port for easy assembling;

• With one red power indicator and one blue potentiometer indicator;

• Anti-reverse connection protection feature.

How Does It Work?

This Me Slide Potentiometer can be combined with Me Orion (or other Arduino IO/sensor expansion board) in interactive projects. Move the lever from one side to the other, its output voltage will range between 0 V to the VCC you apply. The VCC Me Slide Potentiometer supports vary from 3.3V to 5V.
 

Note

If you connect this module to Me Orion, please make sure you connect it to port 6, port 7 or port 8.

The Makeblock MG995 Servo Hub is a aluminium high quality part ideal for fitting JR standard, FUTABA standard servos.

Makeblock 820 Coreless Motor has both the  positive pitch and the negative pitch, it is usually used in the four-axis aircraft.

The Makeblock Versatile Cable with Stripped Ends can be used for Makeblock Air Pump Motor Water Pump Motor and in a variety of DIY projects.

Used to replace or supplement connector on NI my-DAQ Kit.

Makeblock air pump motor - DC 12V/370-02PM is widely used for aquarium tank oxygen circulate, a DIY project to fit your needs.

Makeblock air pump motor - DC 12V/3202PM is widely used for aquarium tank oxygen circulate, it can also be used for a DIY project that you dream up.