The PmodMAXSONAR is a single-transducer ultrasonic range finder that uses the MaxBotix® LV-MaxSonar®-EZ1™. Users can measure how far away an object is with an accuracy within 1 inch to over 20 feet away. Information is sent in a variety of ways including UART, PWM, and analog signals.

Features:

• Ultrasonic range finder with effective detection range of 6 in - 255 in (15 cm - 648 cm)
• Detect object distance with 1.0 in (2.54 cm) resolution up to 20 ft away
• Continuous measurement (free run) operation
• Three options for sending range data: UART, analog and PWM
• Small PCB size for flexible designs 0.9 in × 0.8 in (2.3 cm × 2.0 cm)
• 6-pin Pmod connector with UART interface

The Studica Robotics VMX Cable Pack includes JST-GH to 4-pin Dupont cables, a battery adapter cable and a Wallwart Barrel Plug adapter cable for the VMX.

This set of 12 pieces includes,

• 2 x 20cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 2 x 40cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 2 x 60cm 22AWG Cables with Dupont TJC8 2.54mm 3 pin, female to female connectors
• 6 x 3pin Dupont male to male connectors

The PmodACL2 is a 3-axis MEMS accelerometer powered by the Analog Devices ADXL362. By communicating with the chip via the SPI protocol, users may receive up to 12 bits of resolution for each axis of acceleration.

Features:

• Based on the Analog Devices ADXL362 3-Axis MEMS Accelerometer
• Communicates via SPI
• User selectable resolution
• Less than 2 μA of current consumption at 100 Hz output data rate
• Single or double-tap detection capability
• Free-fall detection

The PmodTMP2 is an ambient temperature sensor powered by the Analog Devices® ADT7420. Through the I2C interface, users may appreciate a resolution of 0.0078 °C through 16 bits of data.

Features:

• Uses the Analog Devices® ADT7420
• Up to 16-bit resolution
• Typical accuracy better than 0.25 °C
• I2C interface with 4 selectable addresses
• 240ms continuous conversion time
• Programmable overtemperature/undertemperature control pins
• No calibration required

The Powerpole Extension Cable is 50cm long and 14AWG wire gauge to handle heavier loads.