The Studica Robotics Rubber Grommets (10 pack) are made for channels and plates and/or any structure with a 14mm hole. For use to protect wire or as a bumper.
Specifications:
The Studica Robotics Multi-Mode Smart Servo Motor features all-steel gears with lots of torque.
Note: This servo motor is legal for FIRST (FTC) competitions.
The Studica Robotics Servo Hub Pro can be used with the Multi Mode Servo, Multi Mode Servo 200, and most servos with a 25 Tooth gear.
A Studica Robotics 1mm, 3M screw spacer (25 pack), for use with robotics design builds.
Made from delrin in blue, this M3 Screw Spacer has a 3.2mm ID x 5.5mm OD x 2mm thick.
Made from delrin in blue, this M3 Screw Spacer has a 3.2mm ID x 5.5mm OD x 5mm thick.
The Studica Robotics Small Thrust Ball Bearing is used for vertical and axial loads to withstand heavy loads. These ball bearings have track grooves on the upper and lower track boards to reduce friction. Use these with structure for any hole where an axial load will be applied.
The Remote Controller is optimized for use on many different platforms. Connect with the included USB cable or in Bluetooth mode. Includes a built-in gyroscope, accelerometer, and 3.5mm Stereo interface for headphones and microphones.
The Studica Robotics Servo Arm Extended can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.
The Studica Robotics RC Servo Arm can be used with the Multi Mode Smart Servo, Multi Mode Smart Servo 200, or most servos with a 25 Tooth gear.
The Studica Robotics nylon Rubber Foot (4 pack) is used with our structure for robotics design builds.
The Studica Robotics U-Channel Bumper (4 pack) is connected to the end of a 48mm U-Channel and helps to eliminate sharp corners that can cause damage when the robot is bumping into other objects. It also creates an aesthetically clean finish to your robot.
