Arduino Uno SMD Rev3 is a microcontroller board based on the ATmega328. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. The Uno differs from preceding boards in that it does not use the FTDI USB-to-serial driver chip.

Standard USB 2.0 cable. Use it to connect Arduino Uno, Arduino Mega 2560, or any board with the USB female A port of your computer. Cable length is approximately 178cm.

MXP Wirewrap provides a large 14 x 21 hole prototyping area on an expansion card compatible with the my-RIO Expansion Port (MXP). The MXP Wirewrap functions as an I/O breakout, with bus traces for GND, 3.3V, & 5V on either side of the prototyping area. The MXP Wirewrap's connector is also keyed to ensure correct connection with your NI my-RIO.

The PmodTMP2 is an ambient temperature sensor powered by the Analog Devices® ADT7420. Through the I2C interface, users may appreciate a resolution of 0.0078 °C through 16 bits of data.

Features:

• Uses the Analog Devices® ADT7420
• Up to 16-bit resolution
• Typical accuracy better than 0.25 °C
• I2C interface with 4 selectable addresses
• 240ms continuous conversion time
• Programmable overtemperature/undertemperature control pins
• No calibration required

Implementing 3D printing just got easier. Introducing the Dremel 3D40 FLEX 3D printer Education bundle, with lesson plans, professional development and easy-to-use software.

Jumper Wire Kit for Breadboard prototyping contains 70 pieces of pre-stripped; pre-formed #22 solid wire in assorted colors and lengths. Storage case included.

An entry-level science kit with 60 safe and fun activities. The topics covered in the kit deal with chemical reactions, acids and bases, chromatography, crystal growing, surface tension, solutions and colloids, expansion of gases, magnetism, optics, growing plants and more. Simple experiments are performed using the contents of the kit and common household items.