The myProtoBoard NI myDAQ accessory board was designed to connect directly to the NI myDAQ hardware. The Protoboard consists of a prototyping space as well as each I/O line from NI myDAQ broken out through quad contact blocks to make wiring easier. The board includes a 9 V battery holder so students can access a supplemental voltage and current source for their projects. In addition, a breadboard is attached for solderless prototyping.
The iWorx TMP-200 Skin Surface Temperature Sensor is a self-contained skin surface temperature transducer (thermistor) with a range of 25 degrees C to 45 degrees C at an accuracy of +/-0.1 degrees. The sensor is a rugged epoxy-sealed disc measuring 12 mm in diameter by 4 mm thick. The TMP-200 is equipped with a phono connector for use with the IX-myDAQ breakout board for the NI myDAQ data acquisition device.
The Stratom X-HUB is a USB and Ethernet hub for myRIO. X-HUB is inserted into the top of myRIO, and is styled for a seamless look. It gives myRIO users access to an Ethernet port and two extra USB ports for a total of three USB ports. The power cable plugs directly into X-HUB to power both X-HUB and myRIO. The USB device cable is also inserted directly into X-HUB with the same functionality as plugging directly into myRIO.
The MXP-MD2 is a next-generation high performance Motor Controller Driver and Sensor Adapter with many added features to make it ready to use in your robot project. The included VNH5019ATR-E Motor Controller ICs are very robust with high current output and several important protection features. Many other I/O options have been incorporated into this design to make it extremely easy to interface to several different sensors.
The adapter includes two connectors for Vernier analog sensors and one connector for Vernier digital sensors. A screw terminal and header pins provide access to myDAQ lines not used by the connectors. This includes the two analog output lines, three digital lines (including the digital lines with the frequency and pulse width modulation outputs), and a +5 volt power terminal.
Studica Blackhawk Expansion Board is a programmable expansion add on for your Mobile Robot.The board is used with the Studica MD2 driver board and the NI myRIO to control servo motors and to add additional sensor expansion and I/O including limit switches and relays.