Electronics
Electronics
Electronics are fundamental components in your robotics design, providing computational power and the control systems necessary for your robots to function autonomously.
Power Switch Plate
The Studica Robotics Power Switch Plate is for use with the Power Switch (part# 70183).
Dupont Single Pin cable (2 pack)
The Dupont single pin, 4 wire, female to female, 22AWG cable (2 pack) is ideal for use with robotics design and competitions.
6V DC Battery Holder, for Smart Robot Servo Programmer
Use it to power the Studica Smart Robot Servo Programmer or any other device requiring 6V output and a TJC8 connector.
Specifications:
- 6V Output
- On/Off Power switch
- TJC8 connector
- Uses 4 x 1.5V AA Batteries (not included)
Cobra Line Follower Sensor
The Studica Robotics Cobra Line Follower Array provides 4 X QRE1113 IR reflectance sensor mounted on a 9mm pitch. Each sensor is comprised of two parts - an IR emitting LED and an IR sensitive phototransistor. When you apply power to the VCC and GND pins the IR LED inside the sensor will illuminate.
Analog Module with JST-SH to JST-GH Cable
Studica Robotics Analog Module with JST-SH to JST-GH Cable. This is used with the Cobra Line Follower Sensor to make it easier to connect.
Remote Control Device - USB & Bluetooth
The Remote Controller is optimized for use on many different platforms. Connect with the included USB cable or in Bluetooth mode. Includes a built-in gyroscope, accelerometer, and 3.5mm Stereo interface for headphones and microphones.
