Makeblock Robot Motion Pack - Blue.

MEDS15 Servo Motor Bracket is specifically designed to attach the MEDS15 Servo to your maker project. Made with durability and versatility in mind, this bracket is made from 6061 aluminum that is 2mm thick.

The chain can be used together with the sprocket for transmission of motion and power. Compared with synchronous belt, the chain can transmit more force and drive large load. During actual operation, the chain can be tailored and pieced up according to actual needs. 

Makeblock 42BYG geared stepper motor is a simple, but very powerful stepper motor with high output torque and response speed but low noise and energy consumptionhas better performance.

It comes with higher torque than 42BYG stepper motor. It can be used as the power motor of some high-performance machine.

Specification:

• Step Angle (degrees) :1.8
• Phase Current: 2.8A
• Wire Number: 4
• Motor Length: 56mm
• Ratio: 5.18:1
• Output Shaft: D shaft 8mm

Makeblock Butt Hinge (40 X 24mm) is a customized stainless steel butt hinge according to the features of the Makeblock platform. 

The Makeblock MG995 Servo Hub is a aluminium high quality part ideal for fitting JR standard, FUTABA standard servos.

• Made from 6061 aluminum extrusion , 8mm thick, anodized surface.
• Compatible with MXL Timing Belt.
• Can also be used as a car wheel. 
• Sold in Packs of 4.

The Makeblock 42BYG Stepper Motor Bracket B has the same function as 42BYG Stepper Motor Bracket. It comes with a width of 40mm to adapt to your DIY project.

Me Slide Potentiometer is one type of potentiometer that can be used to control volume, light intensity, motor speed, movement control, etc. in interactive projects.

Features

• Compatible with the Arduino sensor expansion board;

• Three 4mm mounting holes and one RJ25 port for easy assembling;

• With one red power indicator and one blue potentiometer indicator;

• Anti-reverse connection protection feature.

How Does It Work?

This Me Slide Potentiometer can be combined with Me Orion (or other Arduino IO/sensor expansion board) in interactive projects. Move the lever from one side to the other, its output voltage will range between 0 V to the VCC you apply. The VCC Me Slide Potentiometer supports vary from 3.3V to 5V.
 

Note

If you connect this module to Me Orion, please make sure you connect it to port 6, port 7 or port 8.

Gear 16T is designed for transmitting motion from a motor to another gear or shaft.  You can use a headless screw M3x5 to attach it.

The Makeblock U Bracket B is usually used as the structural support or connection point for shafts, timing pulley 18T, timing pulley 62T, timing pulley 90T and so on. It has seven 8mm center holes that can be attached with 8mm shaft or bearings.