Makeblock Timing Pulley 90T-Blue - 4 Pack

MEDS15 Servo Motor Bracket is specifically designed to attach the MEDS15 Servo to your maker project. Made with durability and versatility in mind, this bracket is made from 6061 aluminum that is 2mm thick.

The Makeblock 42BYG Stepper Motor Bracket B has the same function as 42BYG Stepper Motor Bracket. It comes with a width of 40mm to adapt to your DIY project.

This Makeblock U-Bracket C can operate with 8mm shaft, 8mm bearing and 16mm bearing for mounting 4mm or 8mm shaft. This U-Bracket is made with alluminum alloy material, it can vertically bear high pressure.

Me Slide Potentiometer is one type of potentiometer that can be used to control volume, light intensity, motor speed, movement control, etc. in interactive projects.

Features

• Compatible with the Arduino sensor expansion board;

• Three 4mm mounting holes and one RJ25 port for easy assembling;

• With one red power indicator and one blue potentiometer indicator;

• Anti-reverse connection protection feature.

How Does It Work?

This Me Slide Potentiometer can be combined with Me Orion (or other Arduino IO/sensor expansion board) in interactive projects. Move the lever from one side to the other, its output voltage will range between 0 V to the VCC you apply. The VCC Me Slide Potentiometer supports vary from 3.3V to 5V.
 

Note

If you connect this module to Me Orion, please make sure you connect it to port 6, port 7 or port 8.

Threaded Shaft 4x39mm is an alternative fastener for your maker project. With a threaded end and a smooth end, this shaft works as an ideal tension component. This item is sold in a package of four. Each part is 39 mm in length and is accompanied by a washer.

• Made from 6061 aluminum, anodized surface.
• 18 tooth timing pulley with a center diameter of 4mm.
• Compatible with MXL Timing Belt.
• 2 Headless Screw M3x5 included.
• Sold in Pair.

The Makeblock U Bracket B is usually used as the structural support or connection point for shafts, timing pulley 18T, timing pulley 62T, timing pulley 90T and so on. It has seven 8mm center holes that can be attached with 8mm shaft or bearings.

Makeblock plastic timing pulley 62T is made of plastic, which has a lighter weight. It is used as a car's wheel in DIY designs. Moreover, 12 M4 holes in it also allow to be used as the plate in Makeblock platform.