With robotics design, hubs serve as central connection points or interfaces for attaching various components, modules, or subsystems together. They are used to integrate different parts of a robotic system for joining structural elements, such as frames, chassis, arms, or baseplates.
The Studica Robotics 6mm D-Shaft Servo Hub 25T is made of anodized 6061-T6 Aluminum and is used to connect a servo motor to a D-Shaft axle.
The Studica Robotics 1-1 Motor D-Shaft Kit can be used with the Studica Maverick or any FTC legal motor such as the Neverest Classic (6600 RPM) or the REV HD Hex motor (6000 RPM). The kit includes a faceplate which supports the Studica Robotics building platform. The shaft is press-fit onto the motor's shaft. It is recommended that the shaft be supported by a bearing (part # 76302 for the Studica building system).
The Studica Robotics 6mm D-Shaft Hub (4 pack) is used to connect any Studica wheel and/or motor with a 6mm shaft.
The Studica Robotics 1:1 motor kit can be used with the Studica Maverick or any FTC legal motor such as the Neverest Classic (6600 RPM) or the REV HD Hex motor (6000RPM).
The Studica Robotics Servo Arm Extended can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.
The Studica Robotics RC Servo Arm can be used with the Multi Mode Smart Servo, Multi Mode Smart Servo 200, or most servos with a 25 Tooth gear.
The Studica Robotics Servo Hub Pro can be used with the Multi Mode Servo, Multi Mode Servo 200, and most servos with a 25 Tooth gear.
The Studica Robotics 6mm D-Shaft Low Profile Clamping Hub is an ideal fit for our motors.
Made of aluminum, the Studica Robotics Clamping 6mm D-Shaft Hub is used with flex and drive wheels.
The Studica Robotics Light Weight 6mm D-Shaft Hub (2 pack) are used with 6mm D shafts. They have a 5mm set screw for tight clamping and seven M3 tapped mounting holes.
The Studica Robotics enhanced D-shaft wheel hub kit is ideal for use with the Omni and Mecanum wheels for a strong axle hold.