XL Timing Belt

The Studica Robotics 6mm D-Shaft Servo Hub 25T is made of anodized 6061-T6 Aluminum and is used to connect a servo motor to a D-Shaft axle.

This cable is designed for the encoder that is pre-attached to the NeveRest Series of motors and gearmotors. It has a connector on the opposite end to directly interface with the REV Expansion Hub or the REV Control Hub.

The Multi-Mode Smart Servo 200 rotates at 200RPM. This angular programmable Servo can fill a variety of roles on your robot or project. In standard mode, it operates on a +/- 150-degree range. Using the Studica Smart Robot Servo Programmer (sold separately) the Multi-mode Smart Servo can be configured to run in continuous, standard, and custom angular mode. In continuous rotation mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.  

The Studica Robotics D-Shaft Collar is 6mm ID and 12mm OD. The inside diameter will fit any of the D-Shaft axles.

This 1mm Spacer is used to space gears, sprockets, wheels, and other parts along a 6mm D-shaft. Mix and match various spacer lengths.

The Studica Robotics 12V 3,000 mAh NiMH (nickel metal hydride) Battery Pack, PP45 comes with a w/20 amp fuse. It is a 10-cell, 12-volt rechargeable battery pac k that brings long-lasting power to motors and electronics that are used in the WorldSkills Mobile Robotics Collection.

The Studica Robotics NiMH Battery Pack Charger, PP45, is required to charge the battery.

Note: For the FIRST (FTC) legal battery, choose part# 70025