The NI myRIO Embedded Systems Accessory Kit contains common sensors, devices, and a display.
Required for APUS courses: ELEN430, ELEN435, ELEN436, ELEN440, ELEN498, ELEN499
(NI myRIO not included)
The National Instruments myRIO-1900 is a portable reconfigurable I/O (RIO) device that students can use to design control, robotics, and mechatronics systems.
For motor control, use the MD2 Motor Driver
NI Circuit Design Suite combines Multisim 14.3 and Ultiboard software, to offer students a complete set of tools for circuit design, simulation, validation, and layout. The Circuit Design Suite software download helps you design circuits using intuitive and cost-effective tools.
Note: (Only for sale to Students and Faculty in the USA for lab preparation on personal computers, not for classroom or institutional use.)
Programmable Xilinx 7020 FPGA NI ELVIS—The NI Engineering Laboratory Virtual Instrumentation Suite (NI ELVIS) III is an engineering laboratory device developed for project-based learning.
Studica Blackhawk Expansion Board is a programmable expansion add on for your Mobile Robot.The board is used with the Studica MD2 driver board and the NI myRIO to control servo motors and to add additional sensor expansion and I/O including limit switches and relays.
Requires Studica MD2 Driver Board and NI myRIO with LabVIEW and the Studica Toolkit.
The MXP-MD2 is a next-generation high performance Motor Controller Driver and Sensor Adapter with many added features to make it ready to use in your robot project. The included VNH5019ATR-E Motor Controller ICs are very robust with high current output and several important protection features. Many other I/O options have been incorporated into this design to make it extremely easy to interface to several different sensors.
The NI myRIO Mechatronics Accessory Kit includes a variety of commonly used motors, sensors, and components.
NI myRIO Starter Accessory Kit Contents