The Studica Robotics Servo Hub Pro can be used with the Multi Mode Servo, Multi Mode Servo 200, and most servos with a 25 Tooth gear.

The Studica Robotics Servo Spline Gear is a 30-Tooth Gear with a 25-Tooth Spline. It is used with the Multi-Mode Smart Servo or Multi-Mode Smart Servo 200.

The Studica Robotics 6mm D-Shaft Servo Hub 25T is made of anodized 6061-T6 Aluminum and is used to connect a servo motor to a D-Shaft axle.

Use it to power the Studica Smart Robot Servo Programmer or any other device requiring 6V output and a TJC8 connector. 

Specifications:

• 6V Output
• On/Off Power switch
• TJC8 connector
• Uses 4 x 1.5V AA Batteries (not included)

The Studica Robotics Servo Mount Flat Plate is designed to mount the Multi-Mode Smart Servo (part #75002) to the Studica building structure.

The Studica Robotics Servo Mount Offset Plate is used to mount the Multi-Mode Smart Servo (part #75002) to the Studica building structure.

The Servo Standard Front Mounting Bracket is one option to mount the Multi-Mode Smart Servo (75002) to the Studica building structure.

The Studica Smart Robot Servo Programmer is used for programming the Studica Multi-Model Smart Servo Motor and for testing other standard Servos. Use it to program the Studica Servo motors to switch between continuous mode, standard mode, or any custom angular mode.  

Specifications:

• Requires 6 Volt battery pack with TJC8 connector or use the Studica 6V DC Battery Holder.
• Programming setting modes
  • Standard
  • Continuous
  • Angular