Hex Key Metric 7 Piece Set (1.5, 2, 2.5, 3, 4, 5, 6)

GT2-6mm Timing Belt Clamp w/Set Screw

The Studica Robotics GT2-6mm Smooth Idler Pulley, H Type, w/3mm Inner Bore Bearing is ideal for your robotics design builds.

The Studica Robotics enhanced D-shaft wheel hub kit is ideal for use with the Omni and Mecanum wheels for a strong axle hold.

This GT2 (also called 2GT) timing belt has a 2mm Pitch and 6mm width.

Specifications:

• type: GT2 closed-loop 630mm 
• pitch: 2 mm
• width: 6 mm
• material: neoprene rubber, fiberglass reinforced
• belt shape: circular tooth profile

This GT2 (also called 2GT) timing belt has a 2mm Pitch and 6mm width.

Specifications:

• type: GT2 closed-loop 810mm 
• pitch: 2 mm
• width: 6 mm
• material: neoprene rubber, fiberglass reinforced
• belt shape: circular tooth profile

This GT2 (also called 2GT) timing belt has a 2mm Pitch, 6mm width, and open 1000mm in length. Use any of the GT2 pulleys from Studica and the clamp kit.

Specifications:

• type: GT2 open-loop
• pitch: 2 mm
• width: 6 mm
• material: neoprene rubber, fiberglass reinforced
• belt shape: circular tooth profile

Studica Robotics Analog Module with JST-SH to JST-GH Cable. This is used with the Cobra Line Follower Sensor to make it easier to connect. 

The Multi-Mode Smart Servo 200 rotates at 200RPM. This angular programmable Servo can fill a variety of roles on your robot or project. In standard mode, it operates on a +/- 150-degree range. Using the Studica Smart Robot Servo Programmer (sold separately) the Multi-mode Smart Servo can be configured to run in continuous, standard, and custom angular mode. In continuous rotation mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.  

A Studica Robotics 1mm, 3M screw spacer (25 pack), for use with robotics design builds.

Made from delrin in blue, this M3 Screw Spacer has a 3.2mm ID x 5.5mm OD x 2mm thick.