The Studica Robotics Hex-Shaft and Spacer Bundle includes precision shafts and spacers for robotics building projects. Perfect for drivetrain construction, axle alignment, and spacing adjustments in custom robot designs.
Includes,
The Studica Robotics 6mm Hex-shaft collar clamp (2-piece) has a 6mm Hex-hole and dimensions of 20mm x 8mm.
The Studica Robotics Hex-Shaft Collar is 6mm ID and 12mm OD. The inside diameter will fit any of the Hex-Shaft axles.
The Studica Robotics 20 Tooth GT2-6mm Timing Belt Hex-Shaft Pulley can be used with any of the GT2 belts.
The Studica Robotics 6mm Hex-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.
This 1mm Spacer is used to space gears, sprockets, wheels, and other parts along a 6mm D-shaft. Mix and match various spacer lengths.
This 20mm Spacer is used to space gears, sprockets, wheels, and other parts along a 6mm D-shaft. Mix and match various spacer lengths.
This Studica Robotics 1mm nylon spacer 24-pack is used to space gears, sprockets, wheels, and other parts along a 6mm D-shaft. Mix and match with various spacer lengths.
The Studica Robotics D-Shaft Coupling has an ID of 6mm and an OD of 12mm. It can be used with the 6mm D-Shaft Axle and a 6mm shaft DC motor.
The Studica Robotics D-Shaft Collar is 6mm ID and 12mm OD. The inside diameter will fit any of the D-Shaft axles.
The 6mm x 96mm D-Shaft is made of stainless steel and is used throughout our building system as drive components. The D-Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.
The 6mm diameter D-Shaft is made of stainless steel and is used throughout our building system as drive components. The D-Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.
The Studica Robotics 6mm x 432mm D-Shaft is made of stainless steel and is used throughout our building system as drive components. The D-Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.
The 6mm diameter D -Shaft is made of stainless steel and is used throughout our building system as drive components. The D-Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.
