A 128 tooth gear for robotics design, made from 6061-T6 aluminum, with a 6.35mm thickness and a 14mm hole diameter.
The Studica Robotics 6mm Hex-Shaft Hub (4 pack) is used to connect any Studica wheel and/or motor with a 6mm shaft.
The Studica Robotics 6mm Hex-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.
The Studica Robotics End Piece Plate (2 pack) is commonly fastened to the inside end of the U Channel. As with the other Studica Robotics building components, it has the common hole pattern which makes it easy to connect to other structure with very little or no additional machining required.
The Studica Robotics 30 Tooth Hex-Shaft Gear is ideal for use with robotics design builds.
The Studica Robotics 1-1 Motor D-Shaft Kit can be used with the Studica Maverick or any FTC legal motor such as the Neverest Classic (6600 RPM) or the REV HD Hex motor (6000 RPM). The kit includes a faceplate which supports the Studica Robotics building platform. The shaft is press-fit onto the motor's shaft. It is recommended that the shaft be supported by a bearing (part # 76302 for the Studica building system).
The Studica Robotics 6mm D-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.
The Studica Robotics Gear Pack includes 32, 64 and 128 tooth gears, D-shaft hubs and socket head cap screws, ideal for your robotics designs.
A Studica Robotics 64-tooth gear (2 pack), for use with robotics design builds.
The Studica Robotics 32-tooth gear (2-pack) is ideal for use with robotics design builds.
