6mm XL Pulley, 10 Tooth (2 pack)

The Studica Robotics 6mm D-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.

The Studica Robotics 10-tooth Pulley includes two 5mm Bores, two 10-Tooth Aluminum Pulleys and one 1M XL Timing belt.

The Studica Robotics 60mm OD round groove D-shaft pulley is for use with your robotics design builds.

The Studica Robotics 6mm x 432mm D-Shaft is made of stainless steel and is used throughout our building system as drive components. The D-Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.

This GT2 (also called 2GT) timing belt has a 2mm Pitch, 6mm width, and open 1000mm in length. Use any of the GT2 pulleys from Studica and the clamp kit.

Specifications:

• type: GT2 open-loop
• pitch: 2 mm
• width: 6 mm
• material: neoprene rubber, fiberglass reinforced
• belt shape: circular tooth profile