6mm Hex-Shaft Flanged Bearing (12 pack)

The Studica Robotics 6mm Hex-shaft collar clamp cay be used with the 6mm D-Shape Shaft to secure wheels in their position.

The Studica Robotics 6mm Hex-Shaft Hub (4 pack) is used to connect any Studica wheel and/or motor with a 6mm shaft.

This 20mm Spacer is used to space gears, sprockets, wheels, and other parts along a 6mm Hex-shaft. Mix and match various spacer lengths.

The Studica Robotics 6mm Hex-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.

A Studica Robotics 2-pack of #25 - 24 tooth sprockets for use with robotics design, made of 6061-T6 aluminum.

The Studica Robotics 30 Tooth Hex-Shaft Gear is ideal for use with robotics design builds.

The Studica Robotics Clamping 6mm D-Shaft Hub - v2 is used with flex and drive wheels and is improved for the absolute strongest hold.

The Studica Robotics Hex-Shaft Collar is 6mm ID and 12mm OD. The inside diameter will fit any of the Hex-Shaft axles.

The Studica Robotics End Piece Plate (2 pack) is commonly fastened to the inside end of the U Channel. As with the other Studica Robotics building components, it has the common hole pattern which makes it easy to connect to other structure with very little or no additional machining required. 

The 6mm x 140mm Hex-Shaft is made of stainless steel and is used throughout our building system as drive components. The Hex-Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.