A Studica Robotics 90 Tooth D-Shaft Gear for use with robotics design builds.
Specifications:
The Studica Robotics 30 Tooth D-Shaft Gear is ideal for use with robotics design builds.
The Studica Robotics Servo Arm Extended can be used with the Multi Mode Servo, Multi Mode Servo 200, or most servos with a 25 Tooth gear.
The Studica Robotics Small Thrust Ball Bearing is used for vertical and axial loads to withstand heavy loads. These ball bearings have track grooves on the upper and lower track boards to reduce friction. Use these with structure for any hole where an axial load will be applied.
This GT2 (also called 2GT) timing belt has a 2mm Pitch and 6mm width.
The Studica Robotics Light Weight 6mm D-Shaft Hub (2 pack) are used with 6mm D shafts. They have a 5mm set screw for tight clamping and seven M3 tapped mounting holes.
The Studica Robotics 60 Tooth GT2-6mm Timing Belt D-Shaft Pulley can be used with any of the GT2 belts in your robotics builds.
The Studica Robotics GT2-6mm Smooth Idler Pulley, H Type, w/3mm Inner Bore Bearing is ideal for your robotics design builds.
A 128 tooth gear for robotics design, made from 6061-T6 aluminum, with a 6.35mm thickness and a 14mm hole diameter.
A Studica Robotics 26-tooth bevel gear for use in robotics design and competitions.
The Studica Robotics 30-tooth bevel gear, 1-1 set (2 pack) is ideal for robotics design builds.
The Studica Robotics 32-tooth gear (2-pack) is ideal for use with robotics design builds.
A Studica Robotics 64-tooth gear (2 pack), for use with robotics design builds.
The Studica Robotics Gear Pack includes 32, 64 and 128 tooth gears, D-shaft hubs and socket head cap screws, ideal for your robotics designs.
The Studica Robotics Pro Gear Pack includes 13, 26 and 30 tooth bevel gears, rack & pinion, shaft hubs and socket head cap screws, ideal for your robotics designs.
