60mm OD Round Groove D-shaft Pulley

The Studica Robotics 6mm D-Shaft Face Bearing Block can be mounted on any channel and bracket allowing for a 6mm ID through hole for 6mm shafts (axles). The block has a permanently installed Standard Sealed Bearing and has 8 x M3 tapped through holes for easy mounting.

The Studica Robotics 10mm OD round groove D-shaft pulley is for use with your robot design builds.

The Studica Robotics 1-1 Motor D-Shaft Kit can be used with the Studica Maverick or any FTC legal motor such as the Neverest Classic (6600 RPM) or the REV HD Hex motor (6000 RPM). The kit includes a faceplate which supports the Studica Robotics building platform. The shaft is press-fit onto the motor's shaft. It is recommended that the shaft be supported by a bearing (part # 76302 for the Studica building system).

The Studica Robotics 20mm OD round groove D-shaft pulley is for use in robot design builds.

The Studica Robotics 40mm OD round groove D-shaft pulley is for use with your robotics design builds.

The Studica Robotics 50mm OD round groove D-shaft pulley is for use with your robotics design builds.

The Studica Robotics 6mm x 432mm D-Shaft is made of stainless steel and is used throughout our building system as drive components. The D-Shaft profile is used with pulleys, gears and hubs when tightening the set screws and creating a non-slip connection.

The Studica Robotics 6mm, 10-tooth XL Pulley (2 pack) is ideal for use with the Maverick DC Motor with a 6mm shaft and all 6mm D-Shaft Axles.