Makeblock Plastic Rivet R4060 - 50 Pack

The Makeblock Me Compass is a 3-axis digital compass. The main chip is Honeywell HMC5883L. On-board regulator provides stable power for HMC5883L.

CNC Motor Bracket is specially designed for fixing 555 High-speed CNC Motor on your projects. With the 4mm through holes on this bracket, you are able to connect it to other Makeblock parts to create projects.

Me Slide Potentiometer is one type of potentiometer that can be used to control volume, light intensity, motor speed, movement control, etc. in interactive projects.

Features

• Compatible with the Arduino sensor expansion board;

• Three 4mm mounting holes and one RJ25 port for easy assembling;

• With one red power indicator and one blue potentiometer indicator;

• Anti-reverse connection protection feature.

How Does It Work?

This Me Slide Potentiometer can be combined with Me Orion (or other Arduino IO/sensor expansion board) in interactive projects. Move the lever from one side to the other, its output voltage will range between 0 V to the VCC you apply. The VCC Me Slide Potentiometer supports vary from 3.3V to 5V.
 

Note

If you connect this module to Me Orion, please make sure you connect it to port 6, port 7 or port 8.

This Makeblock U-Bracket C can operate with 8mm shaft, 8mm bearing and 16mm bearing for mounting 4mm or 8mm shaft. This U-Bracket is made with alluminum alloy material, it can vertically bear high pressure.

Standard USB 2.0 cable. Use it to connect Arduino Uno, Arduino Mega 2560, or any board with the USB female A port of your computer. Cable length is approximately 178cm.

The Makeblock 42BYG Stepper Motor Bracket B has the same function as 42BYG Stepper Motor Bracket. It comes with a width of 40mm to adapt to your DIY project.

Makeblock Bracket P1 is a convenient fastener. These specially designed brackets help create connections within your maker project. They are compatible with most Makeblock motion and structural parts.

The Makeblock Me Touch Sensor will be triggered by finger touch. Users can also connect the "TOUCH" pinhole to metal and touch the metal to trigger the sensor. This touch sensor give you the ability to adjust the sensitiity to fit your project. It needs 0.5s for the self-calibration after energized.