Makeblock Me UNO Shield

Me Slide Potentiometer is one type of potentiometer that can be used to control volume, light intensity, motor speed, movement control, etc. in interactive projects.

Features

• Compatible with the Arduino sensor expansion board;

• Three 4mm mounting holes and one RJ25 port for easy assembling;

• With one red power indicator and one blue potentiometer indicator;

• Anti-reverse connection protection feature.

How Does It Work?

This Me Slide Potentiometer can be combined with Me Orion (or other Arduino IO/sensor expansion board) in interactive projects. Move the lever from one side to the other, its output voltage will range between 0 V to the VCC you apply. The VCC Me Slide Potentiometer supports vary from 3.3V to 5V.
 

Note

If you connect this module to Me Orion, please make sure you connect it to port 6, port 7 or port 8.

The Makeblock Me RGB LED V1 is a shiny Me series module which has 4 full color ws2812 RGB LEDs. It has an integrated chip giving you control of each LED individually to adjust its brightness and create any color by mixing different amounts of red, green, blue.

The Makeblock Me 4 Button can be used in a variety of projects. The Me 4 Button can work as function button or direction button to control your robots. There are 4 momentary buttons on the PCB board which have a great “click” to them. They all share an analog output and different analog values reflect different buttons. You can easily connect it to Me BaseBoard V1.0 or Me BaseShield V2.0 by 6 Pin RJ25 cable.

The Makeblock Me Infrared Receiver Decode module is designed for receiving infrared signals and controlling the robotics from the infrared remote control. The Infrared Receiver Decode can receive signals well within 10 meters. It may be unable to obtain signal from further than 10 meters. The Makeblock Me Infrared Receiver Decode is simple to wire, easy to program, the controller is compatible with Arduino.

The Makeblock Me Touch Sensor will be triggered by finger touch. Users can also connect the "TOUCH" pinhole to metal and touch the metal to trigger the sensor. This touch sensor give you the ability to adjust the sensitiity to fit your project. It needs 0.5s for the self-calibration after energized.

The Makeblock Me Compass is a 3-axis digital compass. The main chip is Honeywell HMC5883L. On-board regulator provides stable power for HMC5883L.

MEDS15 Servo Motor Bracket is specifically designed to attach the MEDS15 Servo to your maker project. Made with durability and versatility in mind, this bracket is made from 6061 aluminum that is 2mm thick.

The Makeblock U Bracket B is usually used as the structural support or connection point for shafts, timing pulley 18T, timing pulley 62T, timing pulley 90T and so on. It has seven 8mm center holes that can be attached with 8mm shaft or bearings.