Makeblock Plastic Timing Pulley 62T - 4 Pack - While supplies last.

The Makeblock U Bracket B is usually used as the structural support or connection point for shafts, timing pulley 18T, timing pulley 62T, timing pulley 90T and so on. It has seven 8mm center holes that can be attached with 8mm shaft or bearings.

• Made from 6061 aluminum, anodized surface.
• 18 tooth timing pulley with a center diameter of 4mm.
• Compatible with MXL Timing Belt.
• 2 Headless Screw M3x5 included.
• Sold in Pair.

Me Slide Potentiometer is one type of potentiometer that can be used to control volume, light intensity, motor speed, movement control, etc. in interactive projects.

Features

• Compatible with the Arduino sensor expansion board;

• Three 4mm mounting holes and one RJ25 port for easy assembling;

• With one red power indicator and one blue potentiometer indicator;

• Anti-reverse connection protection feature.

How Does It Work?

This Me Slide Potentiometer can be combined with Me Orion (or other Arduino IO/sensor expansion board) in interactive projects. Move the lever from one side to the other, its output voltage will range between 0 V to the VCC you apply. The VCC Me Slide Potentiometer supports vary from 3.3V to 5V.
 

Note

If you connect this module to Me Orion, please make sure you connect it to port 6, port 7 or port 8.

The Makeblock Me Compass is a 3-axis digital compass. The main chip is Honeywell HMC5883L. On-board regulator provides stable power for HMC5883L.

Makeblock Bracket P1 is a convenient fastener. These specially designed brackets help create connections within your maker project. They are compatible with most Makeblock motion and structural parts.

Makeblock slide unit bushing with copper sleeve is frequently used as the slider platform in motion can connect the shaft 8mm in 3D printer or support some parts such as stepper motors or brackets. 

8 M4 holes on two sides of this slide unit are compatible with all Makeblock motion and structure components.

• Made from 6061 aluminum extrusion, anodized surface. Excellent strength and twist resistance.
• With thread hole in the middle that compatible with the Fully Threaded Rod.
• Other holes without thread can be drilled for 4mm shaft.
• Threaded slot enables easy and flexible connection.
• Cross-sectional area 8x8mm, length 80mm.

• Made from 6061 aluminum extrusion , 8mm thick, anodized surface.
• Compatible with MXL Timing Belt.
• Can also be used as a car wheel. 
• Sold in Packs of 4.