The NavX2 IMU Robotics Navigation Sensor (navX2-Micro) is a great sensor for orientation in competitive robots. The navX2-Micro is a second-generation 9-axis inertial/magnetic sensor and motion processor. 

The Robotics Sensor & Motor Training Kit from Studica Robotics is an affordable turnkey solution that allows you to teach your students how to control sensors and motors using LabVIEW and NI myRIO. It includes two project boards, one with different motors and the other board with most of the standard robotics sensors.

Learn How to Control Motors, Sensors & Actuators with LabVIEW & NI myRIO.

(NI myRIO, LabView and computer are not included).

Ideal for the myRIO.

• Inside Contact Diameter: 2.1mm
• Outside Contact Diameter: 5.5mm
• Termination Style: Solder Cup
• Voltage Rating: 12 V
• 6 Amp
• 1 meter cord length
• 18AWG or 20AWG wire guage
• DC connector type

35695: Idler Gear Z 15

36264: Gear Wheel Z 30, M 1,5

The M3 x 10mm low profile screw with Kep Nut is a 304 Stainless Steel M3 Din 7991 countersunk hex socket flat head screw with a matching Kep Nut. This package is made for the Slide Rail, 288mm Length, 180mm Stroke and the Slide Rail, 384mm Length, 240mm Stroke

The Studica Robotics 38mm Omni Wheel was designed as an odometry wheel that can fit inside most channel sizes. For ease of use, three cores were designed to fit the 6mm D-Shaft, 5mm Hex Shaft, and 7mm Hex Shaft. The wheel is open for easy use in any ecosystem with the provided different-sized cores.

Keep your robotics components and tools safe and organized with the Studica Robotics Toolbox in sleek black. Built for portability, durability, and team convenience.

• • 150mm Length
  • 3 Position
  • TJC8 FH-MC on 2 Split Ends
  • TJC8 MH-FC on single end
  • Twisted Cable
  • Colors: White, Red, Black (red in middle)
  • 24AWG Guage

·      450mm Length

·      3 position

·      TJC8 MH-FC on one end

·      TJC8 FH-MC on the other end

·      Twisted cable

·      Colors: White, Red, Black (red in middle)

·      24AWG Guage

This cable is used and is included with each NavX2-Micro Robotics Navigation Sensor and is used for Control / Expansion Hub.

The NavX2 Micro IMU, (Inertial Measurement Unit), Robotics Navigation Sensor, is a great small footprint sensor for precise robot orientation in competitive robotics challenges. The navX2-Micro is a second-generation 9-axis inertial measurement unit magnetic sensor and motion processor. Designed for plug-n-play installation onto robots such as those used in the WorldSkills Robotics Compentitions, FIRST Technology Challenge (FTC) and the FIRST Robotics Challenge (FRC), the navX2-Micro helps you Build Better Robots by adding sophisticated navigation capabilities to your robot builds.
 

IMPORTANT NOTE:  To avoid having the navX2-Micro reset due to a RoboRIO brownout, connecting the navX-Micro to the RoboRIO via USB is highly recommended.

The Studica Robotics Servo Spline Gear is a 30-Tooth Gear with a 25-Tooth Spline. It is used with the Multi-Mode Smart Servo or Multi-Mode Smart Servo 200.

The Studica Robotics 3mm pattern spacer (10 pack) is designed for use with your Robotics builds and design.